Powerful compressed air pipe-milling machine with a feed rate of 3-1/8 [80] in/min[mm/min] for pipes up to dia. 59 [1,500] in[mm].
- Sawing of steel and gray cast iron water pipes up to a wall thickness of 7/8 [22] in[mm].
- Cutting of gray cast iron water pipes up to a wall thickness of 9/16 [15] in[mm].
- Motor drive parts in stainless construction. The pneumatic motor’s vents are resistant to swelling.
- Operation in low water possible after test.
- The optionally available guide chain guarantees straight cuts without offset.
- Simple setup/shortened side plates ensure less space is required around the machine. In addition, weight optimization means that only two persons are required to set up the machine.
- Horizontal and vertical dividing without extra investment.
- The feed movement can be switched on and off.
- Tool works independently.
